Replacing Bathroom Vanity Tops and Mobile Home Countertops

Start with what's already there

Before anyone talks about stone, look closely at the top you have now. Note its length and depth, whether it has a backsplash or side splashes, and how the sink is mounted. Take photos of the plumbing under the sink, the faucet and the surrounding walls. Those pictures answer a lot of questions before a single measurement is taken. A wide shot of the whole room helps too, because it shows how the top meets the walls, the door swing and the tub or shower.

Ask before you pull anything out. The old top and sink usually need to come off and the plumbing reconnected in a sensible order, and it's easier on everyone when that is planned with whoever is installing the new one.

Single or double vanity

A single vanity top holds one sink and is often a modest piece. A double vanity holds two, and the top is either one long piece or two shorter ones joined at a seam. A long single piece looks clean, but it is heavy and awkward to carry, so it's worth thinking through the path from the door to the bathroom, including turns in hallways.

On a double vanity, the sink centers should leave each person enough elbow room and enough counter on each side of the bowl. The faucet holes need to line up with each bowl too. If your vanity has a corner or an L layout, mention it early, because that changes how the top is cut.

Undermount, drop-in and vessel sinks

An undermount sink hangs below the stone, so the edge of the cutout is exposed and polished, and you can wipe water straight into the bowl. The fabricator needs the exact bowl dimensions or the sink itself, and the sink is fixed to the underside with clips and adhesive. A drop-in sink sits on top of the surface and rests on its own rim, so the cutout is simpler. A vessel sink sits entirely on top, and the stone only needs holes for the drain and faucet.

Decide on the faucet before the top is made. Single-hole, centerset and widespread faucets all need different hole patterns, and holes are drilled in the shop, not on site. Bring the faucet model or its spec sheet along, and don't guess.

What's different in a mobile home

Manufactured homes often have lighter cabinet boxes than a site-built house, and walls and floors can be a little out of square. Stone is heavy, so it's worth checking that the cabinets and the floor beneath them are sound. Pay particular attention around the sink, where slow leaks can leave the cabinet base soft or swollen. A damaged base is better replaced before stone goes on top of it.

Doorways and hallways in a mobile home can also be narrow, which matters when a long top has to be carried in. Tell your installer about any tight spots in advance so the pieces can be planned to get in cleanly. Ask, too, about the wall surface behind the countertop, since it's what any backsplash will rest against.

What to measure and note

• The length and depth of each run, taken at the front and at the wall, because walls are rarely square.
• The sink model, the bowl size and whether it mounts under, drops in or sits on top.
• The faucet type and the number of holes it needs.
• Backsplash height and any side splashes you want.
• Cooktop or range cutouts, for a kitchen.
• Photos of the plumbing and of any tight doorways on the way in.

Bath and mobile home work at Raccoon

Raccoon Stone & Tile Works supplies and installs bathroom vanity tops as well as kitchen countertops, and a 2025 review describes a mobile-home project. That customer wrote that the kitchen and bathroom countertops in their mobile home were replaced, and that the master bathroom was done in April 2025, and they thanked Connie and the crew.

The shop serves Byron, Warner Robins and Macon and a radius of roughly sixty miles around Byron, and templating, fabrication and installation all happen in house. It has been a family shop since 1998.

If you're planning a bathroom or a mobile home kitchen, call (478) 956-2222 or stop by the yard at 2347 GA-247 Connector in Byron, open weekdays from 8 to 5, and bring your measurements and photos.